Search within model. Add to Cart. Control Panel. Wiring Information. Wiring Information Series Popular Parts. Drive Belt. Drum Support Roller. Drum Glide. Idler Pulley Wheel Assembly. High Limit Thermal Fuse. Thrust Washer. Single Drum Glide Felt Pad. Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built and later. This dryer maintenance kit contains all of the parts that are commonly defective when the dryer is noisy.
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad. Dryer drum support roller kit.
Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self-lubricating. Dryer heating element thermal cut-off thermal fuse degrees and high limit thermostat degrees, with wiring kit. If the dryer does not heat the thermal cut off may have blown and a new high limit thermostat is needed. Dryer door switch assembly.
A few screws falling out would cause this as well. Actually yours was a sound most folks will not hear, mainly because they don't remove the screws in back of the dryer. The Maytag is entirely serviceable from the front, so any screws removed in back can result in damage if they are not replaced prior to operating the dryer. Kind of like leaving a wheel off your car and then driving it We were discussing what can cause a squeal and how to repair it properly.
Thankfully, Al provided the link to the manual so that no one would be tempted to remove any rear screws to perform the repair. I've oiled dryer rollers a couple of times.
Both times it was back within a week replacing the rollers because the squeaking returned. I don't like callbacks so now squeaking rollers are replaced, dry. A little graphite doesn't hurt though.
Drum Support Roller Part If they look ok I remove the rollers and sand down the shafts. I lube the shafts and rollers and re install them. Zoomspout oil is safe for dryers.
You lube up them rollers and they start chirping 2 weeks later then that is a venting probo like Jimbo said. But yeah I see your point go ahead and replace them and be done with it unless of course their is a vent problem and them new rollers start sanging a song 2 weeks later.
Pages: [ 1 ] Go Up. The drum glides are on the lower front corners of the inside of the bulkhead. They are riveted in place. If you need to change them, you must drill out the rivets and rivet new ones in place. The rivets come with the glide kit.
The drum support roller shafts are held onto the rear bulkhead with a nut. Figure ML-4 Remove the nut to remove the roller wheels. The front and rear drum seals can also be inspected for wear at this point. They are glued onto the front and back bulkheads. If you need to replace them, you must scrape off the old adhesive and glue in new ones.
In electric models, the heater element is located inside the heater box on the right side of the baseplate of the machine. Test it for continuity as described in Chapter 2, and if defective, replace the heater box. Don't forget to check that the idler rolls smoothly. Replace if sticking or binding, by pulling off the spring clip that holds the idler pulley to its shaft.
Getting the belt around the idler in these clothes dryer machines can be a real son-of-a-gun.
0コメント